You are implementing a new frame relay network to provide connectivity between you offices. To do this, you set up the frame relay network using point

You are implementing a new frame relay network to provide connectivity between
you offices. To do this, you set up the frame relay network using point-to-point
sub interfaces.

Which of the following does NOT need to be configured?
A. The Frame Relay encapsulation on the physical interface.
B. The local DLCI on each subinterface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point.


Answer: C

Explanation:
When using point to point subinterfaces in a frame relay network, the subinterfaces will each have their own IP addresses and will each be contained within their own IP subnet.
The physical interface does not require an IP address. Incorrect Answers:
A. The physical interface will need to be configured with a layer two encapsulation type, so in this case it must be frame relay.
B. The subinterfaces will have the local DLCI assigned to each one, using the
"frame-relay interface-dlci" command for each of the subinterfaces.
D. Each subinterface should be configured as a point to point network type.